The Amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation. It allows for pin point identification even in the most congested cable bundles. Our unit can be used with any tone generator.

Features:

• Works with any Tone Generator (62-160) to identify wires
• Battery cap allows quick and easy battery replacement
• Volume control for increased sensitivity and adjustable to suit work environment
• Recessed ON/OFF button prevents battery drain
• Battery low indicator
• 9 volt battery included
• Tip can be replaced without opening case
• Flat tip included

Tone Generator

Use the IDEAL tone generator (62-160) to apply a tone signal to a wire pair or single conductor, and trace with an amplifier probe (IDEAL 62-164). The tone generator allows technicians to identify that wire within a bundle, at a cross-connect, or at a remote end. It can be used on twisted pair, coax, and de-energized AC wiring.

Features

• Three different tones selected from front panel
• Tone can be added in any status – allows test sets without monitor feature to pick up tone
• Easy to change battery – no tools needed
• Separate Talk Battery status for increased voltage and power for test sets
• Auto-OFF of tone after three hours to conserve battery life
• Constant tone amplitude over life of battery
• Two tone amplitude – normal and half
• No power draw in continuity status with leads open
• RJ jack allows use of modular cable or alligator clips
• Low battery LED indicates when to change battery
• 9 volt battery included