Categories

Excellent

4.83 / 5

9433 Reviews

Robert

Excellent service!

Steve

The service is always very good!! I would highly recommend!!

Richard

I bought 300m of cat5e cable, I didn't know exactly what I wanted but I got there eventually, maybe the website could be setup to compare all the similar products so I know if I'm spending more than I need. Apart from that the goods arrived very quickly, next day I think. The kit for putting the plugs on the ends of the cat cable was complete for the task, the only downside was the little red cable stripping thing which cuts a bit too deep for cat wire and exposed the bare copper if you are not very careful. It comes with 100 plugs and 100 boots which seemed well adequate.

Read all reviews.

More Info
Spec Sheet

The 'Easy' RJ45 Crimp tool works perfectly with the 'Easy' Cat 6 UTP & FTP Pass Through Plugs.
With its added cutting function, this crimp tool trims off the excess wires as it crimps the RJ45 plug.

- For use with RJ45 Pass through plugs
- Can be used to cut outersheath of cable

See below for the 4 step 'Easy' Instructions


1	Remove approximately 20mm of outer jacket using the multi-purpose crimp tool.

2	Arrange wires into the correct colour code sequence (most commonly TIA 568B). Slot cable into the plug pushing the wires through. Outer sheath of cable should sit inside the plug as far up as possible.

3	Press the ‘Lock’ Button on Crimp tool to open it ready for use. Insert the loaded RJ45 plug into the socket and squeeze the handle to crimp the plug, the excess wire will also be trimmed at the same time.

4	If you have followed the instructions you should now have a fully working RJ45 Connection.